allsun Auto Brake Fluid Tester LED Quality 180°Pucker in Buzzer Diagnostic Tool

Description

DESCRIPTION
PAYMENT
SHIPPING
RETURN POLICY
CONTACT US
allsun Auto Brake Fluid Tester LED Quality 180°Pucker in Buzzer Diagnostic Tool
Instruction
This tester can be used to test the quality of brake fluid.It can indicated whether the brake fluid under test can still be used safety or needs to be replaced.It is a very useful tool for ensuring good braking effect anf driving safety.
Features
LED Indicator
Yellow LED light - BAD quality
Red LED light and buzzer sounds - UNSAFE quality
Foldable testing rod 180°pucker
Handheld compact design
Buzzer warning for exhausted battery
It complies with all essential health and safety requirements set out in European Directives
(CE marking)
Specifications
LED display (4 LED's)
Built-in buzzer
180°C pucker folding rod
Power Supply : 1 x 9V(6F22) battery (NOT included)
Length of testing rod : 134mm
Dimension : 175 x 70 x 29mm
Weight : Approx. 160g
Approval : CE approved
Calibration Procedure
Before using, you should calibrate the tester.
To calibrate the tester:
1.
Clean the test head and make it dry.
Note:The test head consists of the two electric poles and the short cylinder connecting with the two electric poles.
2.
Insert the test head into the new brake oil about 2cm deep,or expose the test head in dry air directly.
Note:If you choose to use new brake oil to calibrate the tester,this new brake oil must be the same type as the brake oil you want to test later.
3.
Press and hold down the “ON”button,wait about 3 seconds,then use a suitable screwdriver to adjust the adjustor.When the first green LED just lights up and the other LEDs are off,stop adjusting the adjustor.Now the tester is ready for use.
Note:Don’t release the “ON” button until the calibration is finished.
All right reserved.